1, PTC liquid heater structure. figure 1 Is the structure diagram of the immersion liquid heater figure 2 It is the position where the heater is placed in the container. Vertical heating tube installation is relatively simple, but the tempe....
1. The air heater structure The air-heated structure is divided into a charged type and an insulated type according to whether the heat sink is electrically charged. Figure 1 is a charged air heater. The radiator is electrically charged. The....
The heating power varies with heating time, as shown in Figure 9. At the beginning of power-on, the initial power is still relatively small (the initial power is usually 1/3 to 1/5 of the maximum impact power), then the heating power is gra....
Electric vehicles now use PTC semiconductor ceramic components to heat the air or recycle water for heating. Due to the high voltage and high temperature, its reliability and safety have a very significant impact on the vehicle and personal....
Introduction to PTC thermistors PTC thermistor heating elements are high-tech products that are modern and future. It is widely used in light industry, residential, transportation, aerospace, agriculture, medical, environmental protection,....
Each thermistor has parameters such as withstand voltage, withstand current, maintain current and action time. You can choose the parameters of the product according to the requirements of the specific circuit. The specific methods are as fo....
1, rated zero power resistor R25 Zero power resistor. When the PTC thermistor value is measured at a certain temperature, the power consumption added to the PTC thermistor is extremely low, so that the resistance change of the PTC thermisto....
The self-recovering fuse is made of a conductive material added with a conductive material. The basic principle is a balance of energy. When a current flows through a component, heat is generated, and a part of the generated heat is emitted....
1, resistance-temperature characteristics Although there is a slight difference between the normal temperature and the Curie point temperature, POSISTOR still shows almost constant resistance-temperature characteristics. Its resistance-temp....
PTC refers to the phenomenon of thermistor or raw material with a sharp increase in resistance and positive temperature coefficient at a certain temperature, which can be used as a constant temperature sensor. The raw material thus BaTIO3 or....